ACISOUTVER

Default changed from 16 to 40. Values added for additional ACIS versions. The value is not saved.

ATTDIA

Saved in the registry, not in the drawing.

ATTREQ

Saved in the registry, not in the drawing.

AUPREC

Enhanced to affect only read-only angular units, and all editable angular units whose precision is less than or equal to the current AUPREC value. For editable angular units whose precision is greater than the current AUPREC value, the true precision is displayed.

AUTOSNAP

Valid values are 0 to 63. 63 is the default value. Values added for polar tracking, object snap tracking, and tooltips for polar tracking and object snap tracking.

BLIPMODE

Saved in the registry, not in the drawing.

COORDS

Saved in the registry, not in the drawing.

DELOBJ

Saved in the registry, not in the drawing.

DIMADEC

Default changed from -1 to 0.

DIMBLK

Applies to dimension lines only. Use DIMLDRBLK to specify the arrow type for leaders.

DIMBLK1

Applies to dimension lines only. Use DIMLDRBLK to specify the arrow type for leaders.

DIMBLK2

Applies to dimension lines only. Use DIMLDRBLK to specify the arrow type for leaders.

DRAGMODE

Saved in the registry, not in the drawing.

DWGNAME

Default drawing names include an integer to support working with multiple documents.

LISPINIT

Works only when single-document interface is enabled. When SDI is set to 0, AutoLISP always behaves as if LISPINIT were set to 1.

LOGFILENAME

Saved in the drawing, not in the registry. LOGFILENAME is read-only and the default value depends on the current drawing.

LUPREC

Enhanced to affect only read-only linear units, and all editable linear units whose precision is less than or equal to the current LUPREC value. For editable linear units whose precision is greater than the current LUPREC value, the true precision is displayed.

MAXACTVP

Valid values are 2 to 64. 64 is the default.

OSMODE

Saved in the registry, not in the drawing. Values added for Extension and Parallel object snap modes. Default changed from 0 to 4133.

PLOTROTMODE

Valid values are 0 to 2. 2 is the default. Value added to support the calculation of X and Y origin offsets relative to the rotated origin position.

TILEMODE

Switches between the Model tab and the last current layout tab.

UCSICON

Default changed from 1 to 3.

UCSNAME

Saved on a per viewport basis when UCSVP is set to 1.

UCSORG

Saved on a per viewport basis when UCSVP is set to 1.

UCSXDIR

Saved on a per viewport basis when UCSVP is set to 1.

UCSYDIR

Saved on a per viewport basis when UCSVP is set to 1.

VISRETAIN

Enhanced to support the lineweight property and, when working in Named Plot Style mode, the plot style property.

WORLDVIEW

Value added to change the UCS relative to the UCS specified by the UCSBASE system variable.